H32P PANEL FEATURES
System Mode
Power Indicator
HVAC
Equipment
Terminals
Terminal Blocks
for Zone
Thermostats
Leaving
Air Sensor
24VAC
Transformer
Outdoor
Air Sensor
Zone Damper
Test Buttons
Mode DIP
Switches
Outdoor
Balancing Point
Stage Timer
Adjustment
Heating Limit
Adjustment
Zone Damper
Terminals and LED
Indicators
Table of Contents
Installatio
n…………………………………..2
Operation
…………………………………...3
Set-Up for Various HVAC Equipmen
t … ....3
Leaving Air Sensor
…….…………………...3
Stage Time
r …….…………………………. 4
Damper Wiring
…….……………………..…4
Checkout .
………………….…………….….4
Thermostat Wiring
…………………………..5
Troubleshooting
…………………………….6
Wiring Diagram
……………………………..6
INSTALLATION
The H32P Control is a three (3) zone control panel that can
be used with conventional single stage and two stage heating
and cooling, heat pumps with or without dual fuel and two
speed heat pumps for up to three stages of heating. The
H32P panel is the central control panel that all zone dampers,
zone thermostats, Heat Pump Controls, power transformer,
Outdoor Air (OAS) and Leaving Air Sensor (ZPS) are wired.
When installing the H32P panel it is important to pick a central
location where it is most convenient to bring all the wires.
Most often this is at the furnace or air handler. It is often the
most convenient location and closest to power, the HVAC unit
controls and the zone dampers when typically located at or
near the plenum.
The H32P panel case is made of sturdy ABS plastic and can
be mounted to any flat surface. It is recommended that the
panel be mounted to a wall or return plenum and NOT on the
furnace or plenum where it will be in contact with the
excessive hot temperatures. The panel can be located in an
attic space or in an enclosed cabinet of a rooftop unit. Insure
the panel is not in direct exposure to the elements.
The cover easily removes from the case by pulling firmly and
separating the cover from the case exposing the circuit board.
There are 4 key-hole mounting points in each corner of the
case. The case has openings in the rear of the case as well
as the side for all wiring. Wiring can come from the back as
well as the side in order to make a neat installation.
2
©2017 ZONEFIRST®
