Basic Configuration
To configure the device via web browser, at least one properly-configured PC must be
connected to the LAN port (connected directly or through an external hub/switch to the LAN
port of the device). The configuration can also be performed on a wireless client station (as
Network 2 on Connection Figure 2).
On Ethernet Client
To access the Broadband Wireless Router (AP) via the
Ethernet
interface, the host computer
must install TCP/IP protocol:
Step 1
Choose a client PC and configure it to get a dynamic IP from the Broadband
Wireless Router (AP).
Step 2
Start up your browser and type 192.168.0.1 as the address to enter the web-based
manager.
Step 3
Enter the default username and password. Both values are
admin
(small letters).
Step 4
Go to
Basic
>
WAN Setting
to finish basic configuration. From the drop-down list
select your WAN connection type. Available options include:
Bridge
, Obtain an IP
address automatically,
PPPoE
and
Specify an IP address
.
According to the type you selected, different parameters will appear. After you
finish setting all the parameters, click
Apply
.
Note:
You should contact your ISP for the correct connection type and its
corresponding configuration information.
Step 5
Perform the task of
Save
and
Reset
to have new settings take effect. When the
connection is established, the client PCs can access the Internet or remote network
through the Broadband Wireless Router (AP).
On Wireless Client
Step 1
Install the wireless card driver and verify the wireless setting is as below:
1. The default SSID:
IEEE 802.11 LAN
2. WEP encryption is
disabled
. Authentication Type is
Open Key
(or
Open
System
according to your Wireless LAN Card).
3. Use
Infrastructure
connection mode.
Step 2
Check that the TCP/IP protocol is installed on your wireless client PC. Configure it
to get a dynamic IP from the Broadband Wireless Router (AP).
Step 3
Enter the default username and password. Both values are
admin
(small letters).
Step 4
Go to
Basic
>
WAN Setting
to finish basic configuration. From the drop-down list
select your WAN connection type. Available options include:
Bridge
,
Obtain an
IP address automatically
,
PPPoE
and
Specify an IP address
.
According to the type you selected, different parameters will appear. After you
finish setting all the parameters, click
Apply
.
Note:
You should contact your ISP for the correct connection type and its
corresponding configuration information.
12
