3
2
1
SV-G (E/K/T/C) / A
WARNING
CAUTION
Household Use Only
I
mportant Safeguards
●
Please read these instructions before use, and keep for future reference.
●
The illustrations used in this instruction manual may differ from the actual
product you have purchased.
Note: The rattling noise that may be heard when the Main Body is shaken comes from
the metallic foil used in the vacuum insulation to increase heat (cold) retention,
and does not indicate a malfunction.
STAINLESS STEEL
VACUUM BOTTLE
Instruction Manual
Model
SV-G
Do not allow infants or small children to use this product. Keep out of the
reach of infants and small children.
Be sure to follow the instructions.
These WARNINGS and CAUTIONS are intended to prevent property damage or
personal injury to you and others.
■
The degree of danger or damage by the misuse of the product is indicated as follows:
Indicates risk of injury or
property damage if
mishandled.
Indicates risk of serious
injury or death.
WARNING
CAUTION
■
Prohibited or required actions are indicated as follows:
Indicates a prohibited operation.
Indicates a requirement or instruction
that must be followed.
When using filled with a hot beverage:
● Do not open the Spout
with the product tilted
or close to your face,
as this may cause the
beverage to spurt out
and scald you.
● Be careful, as it may cause scalding.
● Pour slowly without tilting the product
suddenly.
● When pouring hot beverages into the Main
Body, be careful not to let it tip over.
● Always use the Cup when drinking hot
beverages. Never drink directly out of the
bottle.
Do not attach parts other than those
specifically designed for this product.
Do not disassemble the product
(other than parts designed to be
disassembled).
Do not use the product if its thermal
insulation performance has
deteriorated.
Do not use if water enters
the Vacuum Layer.
Drinking the water that
seeps out from the Vacuum
Layer may cause illness.
Do not hold the product by the Cup or
Stopper when carrying it, as the
product may fall and cause injuries.
Do not use this product for other than
storing and keeping beverages hot or
cold.
Do not place near heat sources such
as gas stoves, ovens, and heaters, as
doing so may cause burns or product
malfunction.
Do not heat in a microwave, as doing
so may cause sparks.
Do not place near open flames (from
gas stoves, etc.), on top of electric
heaters, or IH cooking devices, as
doing so may cause a fire or
malfunction.
Do not drink out of the product while
driving.
Never fill the product with the
following:
● Dry ice or carbonated drinks
● Liquids high in sodium such as soup or
Kobu-cha
● Dairy products or fruit juice
● Fruit pulp or tea leaves
Do not scratch or rub the design on
the outside of the Main Body
strongly using fingernails or hard
objects, as this may cause the
design to come off.
Do not remove the
sticker on the bottom
of the Main Body.
Fill the Main Body only up to
the level shown in the
illustration.
Always make sure that the parts are
attached during use.
Make sure that there is no beverage
leakage before using the product.
Consume beverages within the same
day.
Leaving beverages for a long time may
cause them to spoil. It may also cause
the beverage to leak out or the Stopper
or Cup to burst.
Thoroughly clean the inside of the
Main Body, the Mouth, the Stopper,
and the Cup after every use.
Be particularly careful after filling the
product with sports drinks.
Break ice cubes into smaller pieces,
as failure to do so may cause
deformation of the Main Body and
leakage.
Place the product vertically when
carrying it in a bag to prevent leakage
or condensation.
Avoid dropping or hitting against
hard surfaces.
After adding hot beverages, the
pressure inside the product may rise,
making it difficult to remove the
Stopper. If this happens, press the
Button and then remove the Stopper.
There may be condensation on the
inside of the Cup when keeping
warm hot beverages.
Do not shake the product.
Name of Each Part
Mouth
Main
Body
Vacuum Layer
Sticker
Drink Level
Cup
Stopper
Switch
A
Beverage
Inside of the Main Body
Leave a bit of space below
the rim (part A).
Button
Spout
Stopper Gasket
