SELECT A CONNECTION
Press both buttons if on the same page,
or press one, then the other if the con-
nection is across pages. From this
state you can adjust the strength of the
connection by turning the knob.
You can also select a connection by switching to that parameter’s
connection list. Press the grid button and press view until
you see the connection list screen. From here you can adjust
the strength of each connection listed by using the knob.
Highlight a value, click adjust, make your adjustment and click
again to save or press back to cancel.
DELETE A CONNECTION
This can be done by selecting the connection and pressing
delete.
SEE WHAT IS CONNECTED TO A MODULE PARAMETER
When you press a button, all the buttons it’s connected to
will light up. You can also see which connections exist in the
connection list screen.
FINE-TUNE YOUR CONNECTION
When using connections to alter parameters, it’s important to
understand how changes will affect your module. The first step
is to set your destination parameter to your desired CV bias,
which is the point that will either be its minimum (if you apply
positive CV), its maximum (if you apply negative CV), its midpoint
(if you apply CV that swings between positive and negative), or
19
