15
© 2020. All rights reserved.
3. On the setup screen, press the WiFi Scan button, scroll
down to see the list of WiFi signals found, and choose
the WiFi you want the Basement Sentry controller to
use for internet connectivity. Enter the password for the
router you chose in the field indicated. If the password
is correct, the controller will connect to the router and
start sending status updates to zcontrolcloud.com. You
will see the Z Control
®
LED go from blinking to solid.
This could take up to a minute or so.
If the LED does not turn solid, then the password
entered is incorrect, the router’s security is insufficient
(see note below**), or some other network restriction
is in place (see your network administrator). The
controller will return to standby mode if the connection
to router is not successful. If you need to force the
controller into AP mode again, press the Z Control
®
button for 12 seconds (See Figure 1). This will
cause the controller to re-enter AP mode and begin
transmitting the SSID again. Repeat Steps 2 and 3.
4
Click WiFi
Scan
button
** The controller will not connect to
routers with ‘WEP’ or ‘OPEN’ security.
Available
WiFi will
show here.
Choose the
one you
want.
4. Once the controller LED is solid, log in to your
account (or create one) at zcontrolcloud.com.
** The controller will not connect to routers with
‘WEP’ or ‘OPEN’ secUrity.
3
Click WiFi
Scan button
Connecting with your mobile device or computer (Continued)
CONNECTING THE CONTROLLER TO Z CONTROL
®
Summary of Contents for Basement Sentry STBB200
Page 24: ...24 2020 All rights reserved ...
