3
© Copyright 2017 Zoeller
®
Co. All rights reserved.
1. Read all instructions before beginning installation.
2. Be certain that basin is on a firm level surface.
3. Do not use an automatic plumbing vent device.
4. Do not over-torque lid attachment screws.
5. Always use a check valve on the discharge line.
6. Test operation of pump per STEP 6 on page 7.
Ten Helpful Hints For Easy Installation
Performance Characteristics
7. Always provide some means to disconnect basin from
plumbing for maintenance purposes.
8. Run unit at least once a month to verify proper operation.
9. The model number and date code can be found on the lid
warning label.
10. Plug pump into a properly grounded GFCI receptacle.
009897
1. DO read all installation material included with the pump.
2. DO inspect unit for any visible damage caused by shipping.
Contact dealer if unit appears to be damaged.
3. DO clean all debris from the basin and pump.
4. DO always disconnect pump from power source before
handling. DO always connect to a separately protected and
properly grounded ground fault protected circuit. DO NOT
ever cut, splice or damage power cord. DO NOT carry or lift
pump by its power cord. DO NOT use an extension cord.
Do’s And Don't’s For Installing A Unit
5. DO NOT use
a discharge pipe smaller than the pump dis-
charge size.
6. DO test pump immediately after installation to be sure that
the system is working properly.
7. DO review all applicable local and national codes and verify
that the installation conforms to each of them.
8. DO NOT install unit in the ground.
TOTAL DYNAMIC HEAD/FLOW
PER MINUTE
EFFLUENT AND DEWATERING
19.25 ft.(5.9m)
Shut-off Head:
MODEL
15
10
Feet
5
4.6
3.0
34
19
1.5
Meters
43
Gal.
72
129
163
Liters
53
PUMP PERFORMANCE CURVE
MODEL 53
FLOW PER MINUTE
LITERS 0
80
5
20
15
10
GALLONS
TOT
AL
DYNAMIC HEAD
0
2
4
6
10
20
30
160
40
50
FEET
METERS
