Zodiac Z260iQ, Quick Start Manual

Page: 6 / 168

6
Model
Electricity
supply
Max.
current
Cable diameter* Thermal magnetic protection
MD4
220 - 240 V
1 phase
50-60 Hz
10
RO2V 3x2,5 mm
²
16 A
MD5 12,5 16 A
MD6 16,5
RO2V 3x4 mm
²
20 A
MD8 18,5 20 A
Electric supply connections
• Cut the electricity supply before any work inside the appliance (risk of electric shock). The removal of the power
supply has to be such that you can always check from any of the points to which you have access that the power
supply remains removed. If this is not possible, you should provide a disconnection with a locking system.
• Only a qualified and experienced technician is authorised to carry out cabling work within the appliance or to
replace the power cord.
• Make sure that the terminal screws are fully tightened (risk of fire). Incorrectly tightened terminal screws will cancel
the warranty.
• Do not disconnect the electricity supply when the appliance is running. If the electric power supply is interrupted,
wait a minute before restoring the power.
Connect the unit to the power supply and options Heating priority connection
❶
Installation
*Cable cross section suitable for max. length 20 meters.
2
1 - 2: Power for the filter pump
power contactor evaporatorl
: filtration timer
: power contactor (two-pole contac-
tor) for filtration system pump motor
: separate cable for the “heating
priority” function (not supplied)
: heat pump terminal board
: fuse
:
230V/dry contact relay (not
included)
Open the top panel with a screwdriver (4 screws) to access the electrical terminal block .
Insert the power supply cable into one of the cable gland on the rear part of the appliance.
Inside the appliance, fix the power supply cable by threading it through the cable clamp .
Connect the power supply cable to the terminal block inside the appliance as following .
Connect to
power supply
Connect options
(filtration pump,
power supply relay).
L: Live
N: Neutral
: Earth
Terminal block for single phase power supply
14
13
P2 P1
1
2
Cable wiring and protection