![background image](http://html2.mh-extra.com/html/zodiac/vortex-3/vortex-3_owners-manual_4095194011.webp)
9.
Remove the cleaner from the pool using the
handle (refer to Figures 20 and 21). Never lift
the cleaner out of the pool by the floating cable.
10. Loosely coil the cable starting at the cleaner and
go toward the connection point at control unit.
Remove any twists along the way. Store the
cable by wrapping it around the hooks located
at the rear of the caddy.
1
2
Figure 20. Remove Cleaner From Pool
3
Figure 21. keep Cleaner vertical to Drain Water
IMPORTANT
•
Use your cleaner as often as needed to keep your
pool clean.
•
Clean the filter canister after each cleaning cycle.
•
Do not leave your cleaner in the pool on a
permanent basis.
•
At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle
any coils in the cable before storing the cleaner.
4.3 Operating the vortex 4
CAuTION
To prevent damage to the cleaner, be sure to adhere
to the following guidelines:
•
Do NOT remove the cleaner from the pool for 15
minutes after the cleaning cycle ends.
•
Approximately 15 minutes after the cycle is
completed, the light located on the control unit
will flash slowly to indicate that the cleaner may
be removed from the pool. The 15 minute period
allows the motor to cool and will prevent damage to
the cleaner.
•
Remove the cleaner from the pool after the
cleaning cycle is completed and store on the caddy.
•
Never lift the cleaner out of the pool by the floating
cable. Always use the handle to remove it from the
pool. Refer to Figures 20 and 21.
•
Remove the cleaner from pool when super
chlorinating.
•
Do not handle cleaner while it is in operation.-
NOTE
Always make sure the cleaner head is fully
submerged in the water before you begin the
operation cycle.
When the cleaner is powered ON it will remain in
standby until one of the cycle program selection buttons
is pressed. Select either the Cycle I or Cycle II cleaning
program on the control unit.
Cycle I Program
Cycle II Program
Completed in 1.5hours Completed in 2.5 hours
Maximum coverage in
minimal time
Intensive and complete
cleaning
Thorough pool floor
cleaning
Thorough pool floor and wall
cleaning
1.
To start your cleaner, press the desired cycle
button (Figure 18). "Cycle I" is the most
commonly selected cleaning program for
inground pools.
2.
When the "Cycle I" program button is selected
the indicator light will illuminate. The cleaner
will start in a few seconds.
3.
Depending on the state of your pool it is
possible to modify the time of the cleaning
cycle by pressing the button. Pressing the
button will increase the cleaning time by
Page
11
ENGLISH
Zodiac
®
Vortex
™
3, Vortex 4 Robotic Pool Cleaner
|
Owner's Manual