The cleaner seems to be
performing less efficiently.
The brushes have become smooth or
the "wear" indicator shows.
Replace the brushes following the procedure in
Section 5.3, "Replacing the Brushes".
Filter canister is full or dirty.
Clean the filter canister following the procedure in
Section 5.1, "Cleaning the Filter Canister".
Floating cable is excessively coiled or
kinked.
Make sure the floating cable is spread out over the
pool. Ensure the cable is not too tightly wrapped
or coiled when storing. If the problem persists, lay
the cable straight in the sun to relax it and remove
kinks.
vortex 4 Only
symptom
Cause
solution
The remote control does not
work.
The batteries are dead and need to
be replaced.
Replace the batteries in the remote control.
The remote control is not
synchronized to the control unit.
synchronizing procedure:
When replacing the control unit or the remote
control, it is necessary to synchronize the new
remote control with the control unit:
1.
Connect the Vortex 4 to the control unit,
then plug the control unit to the receptacle.
2.
Press OFF + Cycle I buttons for more
than 6 seconds until both lights
flash once:
3. Press and hold the "rotate right" button on
the remote control unit.
4.
The light on the right will flash
5 times
then both
lights
will flash together.
5. The synchronization procedure is
completed when both lights switch off.
Page
19
ENGLISH
Zodiac
®
Vortex
™
3, Vortex 4 Robotic Pool Cleaner
|
Owner's Manual