Recommendations
• Warning, the pH Perfect must be installed by an experienced pool professional.
• Before doing any work inside the housing of the pH Perfect Controller, disconnect the appliance
from the power supply.
• Before installing the pH Perfect Controller, make sure that all the components requires are
present and the instruction manual has been carefully read.
• Failure to comply with the instructions contained in this manual may be harmful to persons,
or cause damage to the appliance.
• During installation of the pH Perfect regulator, check the following:
- the supply voltage is as indicated on the label attached to the side of the appliance.
- the pressure at the injection point is less than 1.5 bars.
- the protective housing on the pump is properly clipped into position.
- the suction tube is immersed with the intake pipe in the can of product to be injected
and is connected to the pump (mark on the lid), then retighten the nut on the connector.
- the inlet pipe will then be connected to both the pump (sign under the lid) and the inlet
pipe to the pool through the injection flap valve.
• The pH sensor, together with the glass elements of which it is composed, is to be handled
with care.
Installation Diagram
• Installation of the pH Perfect on the filtration circuit.
INSTALLATION
Summary of Contents for pH Perfect
Page 20: ...NOTES...
Page 26: ...NOTES...