H0354600.E EN - 2015/01
3
1.3 Technical specifications
Hose length
10 sections of 1 metre
(MX™ 6)
12 sections of 1 m
(MX™ 8 and MX™ 8 PRO)
Cleaner dimensions (L x W x H)
31 x 19 x 22 cm
(MX™ 6)
41 x 19 x 22 cm
(MX™ 8 and MX™ 8 PRO)
Package dimensions (L x W x H)
102 x 23 x 37 cm
(MX™ 6)
102 x 23 x 37 cm
(MX™ 8 and MX™ 8 PRO)
Cleaner weight (body)
2.5 kg
(MX™ 6)
- 3.2 kg
(MX™ 8 and MX™ 8 PRO)
Packaged weight
8.2 kg
(MX™ 6)
- 9.5 kg
(MX™ 8) -
10.5 kg
(MX™ 8 PRO)
Theoretical cleaning width
25 cm
(MX™ 6)
- 36 cm
(MX™ 8 and MX™ 8 PRO)
Filtration capacity
Pool filtration circuit
Minimum power of the filtration
pump
3/4 hp
Speed of movement
8 m/min
1.4 Recommendations for use
•
The pool must be equipped with a self-priming filtration unit with
a full-system flow rate of 12 m³/h and filtration pump
power of 3/4 hp or 550 W.
• During the season, you can leave the device in the water.
•
The cleaner needs to operate in swimming pool water under the following conditions: chlorine < 3 mg/l; pH between
6.8 and 7.6; temperature between 15°C and 35°C. Outside these values, the cleaner's efficiency may be reduced.
• When the pool is dirty, especially when commissioning, remove the largest debris using a net in order to optimise clea-
ner performance.
•
Do not wait until the pool is very dirty and full of algae before using the cleaner, or the filtration system will become
clogged very quickly.
• Remove any thermometers, toys and other objects that might block or damage the cleaner.
• You can operate the filtration pump during a cleaning cycle to filter out the particles placed in suspension by the cleaner.
However, if the behaviour of the cleaner is affected by the jet from the discharge nozzle when the filtration pump is
operational, we advise you to start your cleaner when the filtration pump is not operating.
During the season, we recommend leaving the cleaner in the pool EXCEPT when using the pool.
To remove the cleaner, disconnect the hose, but do not roll it up.
Remove the cleaner from the pool for at least 4 hours when adding chemical products.
2. Assembly and installation
2.1. Determining the suitable hose length for your pool
• The correct hose length is the maximum distance your cleaner
can travel in your pool.
•
It corresponds to the distance between the hose connection
point – the skimmer or suction line – and the point furthest
away from it,
plus
a 1-metre section.
•
If this measurement is greater than 11 m, you can buy additio
-
nal sections from your reseller.
Skimmer or
brush socket
Length
of hose
required
Section with
float
