2. Use 1/2” PVC pipe to connect the MiniJet to the
manifold or plumbing loop. See plumbing
diagram below.
Optional
Loop
Extend Past Last
MiniJet 5' Minimum
MiniJet
Manifold Pipe
Valve
Riser
From
Pump
See Chart for
Proper Sizing
3. When the MiniJets are lined up to project water
streams of equal distance, cut the risers to equal
lengths. When the MiniJets are not set in lines parallel
to the pool edge, valve them separately.
4. Keep the 1/2” feed pipe short, and the manifold or
plumbing loop as close to the beam as possible. Avoid
undue stress on plumbing lines.
5. The manifold pipe should extend 5 ft. past the last
MiniJet.
6. Pressure test the MiniJet.
Pool Start-up
1. Clean the pool water.
2. Remove the threaded 3/8” plug from the MiniJet
housing. (Save plug for winterizing.) Run water through
the MiniJet plumbing to clear the lines.
3. Screw brass jets into threaded fittings. Adjust nozzle
alignment and plumbing valves until the desired
projection is reached.
4. Install MiniJet cover plate.
Winterizing
1. Drain all water from the MiniJet plumbing.
2. Screw the 3/8” plug provided into the nozzle inlet of
the MiniJet housing to protect the unit.
Page 4
ENGLISH
Zodiac
®
MiniJET
®
|
Installation Instructions