![background image](http://html1.mh-extra.com/html/zodiac/medline-7-5/medline-7-5_manual_4009622015.webp)
Page 15 / 55
Issue 1
E
N
G
L
I
S
H
II -1-MAINTENANCE OF THE BUOYANCY TUBE
Your boat’s buoyancy tube is made of NEOPRENE CSM-CR
1670
Decitex fabric, 1500 g/m².
The maintenance recommendations are specified in VOLUME I of the owner's manual.
II-2 INSTALLING THE BUOYANCY TUBE ON THE HULL
If the buoyancy tube has been stored at a temperature below 0°C, leave it for
12 hours at room temperature (20°C) before unfolding it.
You can inflate the non-installed buoyancy tube (pressure 240 mb) and let it
stabilize for around one hour. Then deflate it.
NOTE:
the buoyancy tube is fitted to the hull with the buoyancy tube deflated
1
In order to facilitate the fitting of the buoyancy tube, apply liquid soap to the hull’s rails (A).
2
Place the buoyancy tube bolt rope (a) in the hull rail (b) starting with the front of the hull. Pull the
buoyancy tube to bring it to the water guard near the transom.
3
Repeat for the other side of the buoyancy tube.
The two protective flaps (sealing and exterior) should pass over the hull’s nose.
Summary of Contents for MEDLINE 7.5
Page 28: ...Page 28 55 Issue 2 INSTALLATION AND CIRCUIT ELECTRICAL 16 17 ...
Page 31: ...Page 31 55 Issue 1 E N G L I S H INSTALLATION AND CIRCUIT ELECTRICAL 17 ...
Page 46: ...Page 46 55 Issue 2 VI 1 POSITION OF LABELS 3 4 5 6 1 2 7 ...
Page 47: ...Page 47 55 Issue 1 E N G L I S H LABELLING VI 2 DESCRIPTION OF LABELS ...