Page 9
AquaLink
®
TRi
®
Controller | Installation Manual
Page 8
AquaLink
®
TRi
®
Controller | Installation Manual
CAUTION
Make sure to perform the following step
BEFORE
mounting the enclosure onto the mounting bracket,
otherwise, damage to the threaded hole of the
mounting bracket may occur.
7. Open the front cover of the controller and locate
the fastening hole under the ground bar. Use a drill
size 3/16” to drill through the plastic enclosure.
This is the fastening hole aligned with the threaded
hole of mounting bracket.
8. Line up the slot in the controller enclosure with
the guide in the mounting bracket and hook on to
mount.
9. Secure the controller enclosure to the mounting
bracket with the single fine thread Phillips screw
provided.
Mounting
Bracket
Anchors (4)
Screw
Screws (4)
Controller
Drill a 3/16” hole before
mounting onto the bracket
Figure 1. Mounting the Controller Enclosure
3.2 Mount the User Interface for Remote
Access
For ease of use, you may remove the user interface (UI)
from the controller enclosure and install it in a location
away from the equipment pad.
NOTE:
To set up the UI this way, use the provided
5 metre length of cable. If a longer length is
required this can be purchased from most
leading electronics retailers (common phone
cable with RJ11 jacks should be used).
WARNING
When installing the UI for remote use, UI must be
located where a service professional may access it
and the blanking panel (provided) must be installed
in place on the controller door.
1. Using the holes in the metal bracket as a guide,
drill two (2) holes on the surface where the UI will
be mounted.
2. Screw the bracket to the surface using two (2)
screws.
3. Remove the UI from the front of the controller
enclosure and attach magnetically to the mounting
plate.
4. Use the plastic face plate provided to cover the UI
housing when UI is removed. Attach face plate to
enclosure door with two screws retained from UI
removal.
Section 4. Mains Voltage Wiring
WARNING
Potentially high voltages in the AquaLink TRI
controller can create dangerous electrical hazards,
possibly causing death, serious injury or property
damage. Turn off power at the main circuit feeding
the AquaLink TRI controller to disconnect the power
center from the system.
WARNING
Zodiac Group Australia PTY LTD advises that
any procedure requiring potential contact with live
electrical wiring and/or parts other than cords and
plugs connected to electrical outlets, be completed
by a licensed electrical contractor qualified in pool
equipment as described on the front of this manual.
Failure to follow warning notices and instructions
may result in property damage, serious injury, or
death.
All mains voltage wiring must be done by a licensed
electrical contractor.
NOTE:
See
Figure 2. AquaLink TRI Electrical Wiring
Diagram
for specific wire locations and
connections.