Page 19
AquaLink
®
TRi
®
Controller | Installation Manual
Page 18
AquaLink
®
TRi
®
Controller | Installation Manual
7.8 Temp Calibrate
INSTALL SETTINGS>TEMP CALIBRATE
Adjust temperature displayed on the AquaLink TRI up
or down by 2 degrees.
NOTE
If the temperature is off by more than two
(2) degrees, contact your local service
representative.
TEMPERATURE
CALIBRATE
Water: 26°C
More
SYSTEM SETUP
Label Aux
>
Temp Calibrate
>
Solar Priority
>
Assign JVA
>
Color Light
>
TEMPERATURE
CALIBRATE
Water: 26°C
More
SYSTEM SETUP
Label Aux
>
Temp Calibrate
>
Solar Priority
>
Assign JVA
>
Color Light
>
• Use Up/Down arrows to set new temperature value.
7.9 Solar Priority (if applicable)
INSTALL SETTINGS>SOLAR PRIORITY
NOTE:
You will only see this option if solar heating is
installed in your system.
Enable the system to use solar heat first, when available.
If solar heat is no longer available, the system will
automatically switch to the alternate heat source.
SOLAR PRIORITY
Enable
Disable
More
INSTALL SETTINGS
Color Lights
>
Label Aux
>
Temp Calibrate
>
Solar Priority
>
Assign JVA
>
>
• When solar and heater are enabled the solar will
heat the water until either the thermostat setting has
been reached or solar heat is no longer available.
• If the solar panel is not hot enough, solar heat will
shut off and the other heat source (usually gas
heater) will take over to bring the water up to the
thermostat setting.
7.10 Assign JVA
INSTALL SETTINGS>ASSIGN JVA
NOTE:
If the system is a pool/spa combination, without
solar, only the solar JVA is assignable. If the
system is a pool or spa only system, without
solar, all three JVAs are assignable. The
example shown is for a pool or spa only system
without solar.
Allow Jandy
®
Valve Actuators (JVAs) to be assigned
to any auxiliary on the AquaLink TRI controller, so
that when you select this auxiliary, the valve turns.
Assigning JVAs lets the pool owner control certain
features like diverting water to a waterfall or bank of
spa jets. Multiple JVAs can be assigned to one auxiliary
without extra hardware.
ASSIGN JVA
Intake Free
Return Free
Solar Free
ASSIGN JVA
Intake
/Return/Solar
None
Aux1
Aux2
Aux3
More
INSTALL SETTINGS
Color Lights
>
Label Aux
>
Temp Calibrate
>
Solar Priority
>
Assign JVA
>
>
ASSIGN JVA
Intake Free
Return Free
Solar Free
ASSIGN JVA
Intake
/Return/Solar
None
Aux1
Aux2
Aux3
More
INSTALL SETTINGS
Color Lights
>
Label Aux
>
Temp Calibrate
>
Solar Priority
>
Assign JVA
>
>
