Problem
Possible Cause
Corrective Action
Pump fails to provide sufficient water
Check for correct operation of the pump.
flow.
Make sure pump is sized properly for
required flow rate.
The display says “Lo
Salt level is well below 2,500 ppm,
Maintain a salinity level of 3,000 ppm -
Tmp/Lo Salt”.
depending on water temperature.
3,500 ppm (see Section 4.6 or contact your
local pool professional).
Calcium buildup in the cell
Clean the Cell
NOTE
Salinity readings are taken after 5 minutes and at regular 5 minute intervals. The Salt
warning will turn on when the salt level drops well below 2,500 ppm and it will remain on
until the salt level is raised to 3,000 ppm or slightly above.
Cell life expired.
Replace the cell.
A combination of low water temperature
Check salt level in pool water. If level is
(35°-65°F / 2°-18°C) and lower salt
between 3,000 - 3,500 ppm, no action is
levels (1,500 - 2,000 ppm).
necessary. If salt levels are lower than
2,500 ppm, raise the salinity level to 3,000
- 3,500 ppm (see Section 4.6).
NOTE
Salt levels above 4,500 ppm
may cause corrosion damage.
Salt level too low.
Not enough salt added to pool.
Add salt to pool until salinity returns to
3,000 ppm
(see Section 4.6).
Leak in pool.
Repair pool.
Salt level too high.
Too much salt has been added to pool.
Verify salt levels by testing. Using the most
reliable method available i.e. taking sample
to pool dealer before taking any dilution
action. Backwash or partially drain pool and
dilute with fresh water until salinity returns
to 3,000 ppm - 3,500 ppm.
Metal debris caught between plates or
Remove any debris caught between plates
cell plates that may be touching.
by using a garden hose under moderate
pressure. If plates are loose and touching,
replace the cell.
Strong Chlorine odor.
Presence of excess chloramines
Manually shock the pool
(combined chlorine).
(see Section 4.3).
Chlorine is an oxidizer, which means that
organic waste is being removed from the
water into the air. Strong odors are a part
of this process. If these odors persist
longer than 12 hours, take a water
sample to your local pool dealer.
Page 22
ENGLISH
Jandy
®
Pro Series TruClear
™
ChlorineGenerating System
|
Installation & Operation Manual
