14
15
testinG the WirinG connection
Once a connection has been made between the Controller and the
MagnaPool Control Centre, it will need to be tested.
1. Turn on the power to the Controller and the MagnaPool Control
Centre.
2. If successful, a ‘ ’ symbol will appear in the top right hand corner
of the screen after about 20 seconds.
3. If the controller does not connect, turn power off to both the
devices and try again.
verifY the WirinG connections
To verify the connection:
1. Switch the MagnaPool Control Centre on and check the
controller setting (follow instructions under ‘SETTING
CONTROLLER’.
2. Re-test the connection.
Note: For safety reasons, the system reverts to the OFF setting if the
communication connection is lost.
connection to controller for Pool/sPa
comBinations
To connect the MagnaPool Control Centre to Pool or Spa Valves,
you will need to make a “splice” into the control lines from the
Controller, located inside the controller itself.
For further information, consult the installation manual of the
Controller being used.
connectinG to a controller
connectinG to a controller
