www.znshinesolar.com
Document No.
:
QES/ZX-RD-III032A
- 2 -
(
4
)
Protective clothing (non-slip gloves, clothes, etc.) must be worn during installation to prevent direct
contact with 30V DC or greater, and to protect hands from sharp edges.
(
5
)
Prior to installation, remove all metallic jewelry to prevent accidental exposure to live circuits.
(
6
)
When installing modules in light rain, morning dew, take appropriate measures to prevent water ingress
into the connectors, f. e. using connector endcaps.
(
7
)
Use electrically insulated tools to reduce the risk of electric shock.
(
8
)
Do not use or install broken modules.
(
9
)
External or artificially concentrated sunlight shall not be directed onto the front or back face of the PV
module.
(
10
)
Do not contact module surface if the front or rear glass is broken. This may cause electric shock.
(
11
)
Do not attempt to repair, disassemble or move any part of the PV module. The module does not
contain any reusable parts.
(
12
)
Do not connect or disconnect the module when it is energized or connected with an external power
supply.
2.3
、
HANDLING SAFETY
(
1
)
Do not stand, walk on or lean on the module directly.
(
2
)
Do not damage or scratch the front or backside surfaces of the module.
(
3
)
Do not drag. Scratch, bend the output cable with force or with too tight connection. The insulation of
output cable can break and may result in electricity leakage or shock.
(
4
)
If there is an open fire, please extinguish it with a dry powder extinguisher after disconnecting the power
supply, can not use liquid such as water to extinguish the fire.
(
5
)
Do not install or handle modules when they are wet or during periods of high wind.
(
6
)
At the installation site, take care to keep modules and in particular their electrical contacts, clean and
dry before installation. If connector cables are left in damp conditions then the contacts may corrode. Any module
with corroded contacts should not be used.
(
7
)
Please Do not loosen, unscrew or peel the PV module bolts and frame glue. This may lead to a
reduction of the module’s load rating and potential damage from a fall.
(
8
)
Do not drop PV modules or allow objects to fall down on the PV modules.
(
9
)
Do not touch the terminal box or the ends of the output cables (connectors) with bare hands under
sunlight, regardless of whether the PV module is connected to or disconnected from the system.
(
10
)
Do not discard the modules at will; special recycling is required.