- 5 -
• Compatibility may not be provided for the Bluetooth devices to be manufactured in the future.
• In order to provide optimum connection, make sure the battery of your Bluetooth device
has been fully charged.
• Some Bluetooth devices have energy saving mode. Deactivate energy saving mode,
since it may cause data transmission disturbances.
• In case of incoming call to the connected smartphone, music playback is paused.
Reception of FM radio stations:
1. Use the switch
POWER
(27) to turn on the sound system. By pressing key [
MODE
] or remote
[
MODE
] choose mode FM radio.
2. Shortly press the sound system key [ ] (16) or remote key [FM SCAN], and scanning for range
and memorization of radio station frequencies will begin; frequency will change on display and shortly
the memory cell number of the found transmitter will be shown (for example, "CH02"), and a short
fragment of the transmission will be played.
For early stopping of scanning of FM radio stations, press the key [ ] (16).
When scanning of radio stations is over, broadcast of the first found "CH01" radio station will be
played.
3. Temporarily pressing the key [
] (15) or [
] (17), select any of the memorized radio stations.
Connection of microphones:
Dynamic wireless microphone (included) and/or dynamic microphone with cable can be
connected to the sound system.
1. Switch off the sound system by using the switch
POWER
(27).
2. Turn the echo controller
ECHO
(12), main volume controller
VOLUME
(21) and microphone
volume controller
M.VOL
(6) to the minimum.
3. If you will use an additional microphone with a cable, connect the cable to the port
MIC
(1).
• Before the use of wireless microphone, two R6/AA 1.5V batteries must be inserted.
• Shift the microphone switch in position ON (switched on).
4. Switch on the sound system by using the switch
POWER
(27).
5. Speak into the microphone and set the required volume by using the main volume controller
VOLUME
(21) and the controller
M.VOL
(6). Set the required echo level with the echo controller
ECHO
(12).
6. If the microphone priority mode button
OK PRI
(7) will be locked in pressed position, then,
upon speaking into the microphone, sound from other signal source (for example, USB flash
memory) will be automatically toned down.
Connection of guitar:
Guitar with sound pick-up can be connected to the sound system.
1. Switch off the sound system by using the switch
POWER
(27).
2. Turn the echo controller
ECHO
(12), main volume controller
VOLUME
(21) and guitar volume
controller
GT.VOL
(18) to the minimum.
3. Insert the guitar pick-up cable pin into the socket
GUITAR
(2).
4. Switch on the sound system by using the switch
POWER
(27).
5. Play guitar and set the required volume by using the main volume controller
VOLUME
(21)
and the controller
GT.VOL
(18).
