p. 18/61
4.
Installation of automatic pellet burner
Requirements and recommendations.
4.1.
Some basic requirements for correct installation of automatic pellet
burner of series “GP” :
The burner should be positioned in order to guarantee comfort
maintenance and easy access for cleaning procedures;
The main unit of the burner should be installed on a unit (a boiler, heat
consumer, etc.), which has the appropriate thermal capacity, at least equal
that of the burner and should provide easy access for burner’s grate
cleaning and ash removal;
It is strongly forbidden to install the burner in dwellings, including
corridors;
The installation process of the burner, its attachment and connection of
the power supply and control should be performed by authorized personal
only;
Installation and maintenance of the burner is performed by specialized
trained personal of authorized companies;
Connection of the burner to the power supply and the control board
should be performed by authorized technician only;
Before starting the burner, the heat consumer unit (at which the burner is
attached) should be thoroughly checked in order to guarantee safe
operation of the system;
The maintenance of the burner should be performed by adult person, who
is familiar with the safety procedures and the user manual of the
appliance;
ATTENTION :
the attachment of the main module of the pellet burner of
series “GP” to a heating appliance (in most of the cases – hot water boiler) is
made by screws and corresponding nuts. It is necessary to tighten the main
module of the burner to the appliance by a tool (wrench). It is not permissible to
attach the burner to an appliance by handles, which could allow detachment of
the main module by hand. The installation process of the burner should be
performed by authorized trained technician only, using a tool
;
