Zline RCBR30, Installation Manual And User'S Manual

Page: 4 / 15

1
Gener
al Safet
y
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS 1
WARRANTY AND SERVICE 3
PRODUCT DIMENSIONS 3
BEFORE INSTALLATION 4
INSTALLATION REQUIREMENTS 6
INSTALLATION
7
POWER RATING & ELECTRICAL CONNECTION
8
GAS CONNECTION 9
GAS CONVERSION PROCEDURE 12
INSTALLATION CHECKLIST 16
FINAL PREPARATION 16
ROOM VENTILATION 17
COOKTOP COOKING 17
MAINTAINING YOUR RANGE 20
TROUBLESHOOTING 21
WARNING
An air curtain or other overhead range/cooktop hood, which
operates by blowing downward airflow onto the range, shall not be
used/installed in conjunction with this gas range.
• The manufacturer will not be responsible for any damage to property or to
persons caused by incorrect installation, improper use of the appliance, or failure
to heed the warnings listed.
• The manufacturer reserves the right to make changes to its products when
considered necessary and useful, without affecting the essential safety and
operating characteristics.
• This appliance has been designed for non-professional, domestic use only.
• Do not place any pot or pan on the open oven door. The door is made of glass
and can break under the weight.
• Before beginning installation, please read these instructions completely and
carefully.
• Please observe all local, state and national codes and ordinances. Please ensure
the range is properly grounded. The installer should leave these instructions with
the consumer who should retain for local inspectors use and for future reference.
The plug should always be accessible. Installation must conform with local codes
or in the absence of codes, the National Fuel Gas Code NSIZ223. 1/NFPA54.
Electrical installation must be in accordance with the National electrical code
ANSI/NPA70-latest edition and/or local codes. In Massachusetts: Installation
must be performed by a “Massachusetts” licensed plumber or gasfitter. A “T”
handle type manual gas valve must be installed in the gas line connected to
this appliance. In Canada: Installation must be in accordance with the current
CAN/CGA-fe 149.1 National gas installation code or CAN/CGA-B 149.2,
Propane installation code and/or local codes. Electrical installation must be in
accordance with the current CSA C22.1 Canadian electrical codes Part 1 and/
or local codes.
• The installation of appliance designed for manufactured (mobile) home
installation must conform with the Manufactured Home Construction and Safety
Standard,Title 24CFR,Part 3280 [formerly the Federal Standard for Mobile
Home Construction and Safety,Title 24,HUD(Part280)] or with local codes
where applicable.
IMPORTANT SAFETY INSTRUCTIONS
Gener
al Safet
y