18
17
Remove th
e kick plate
INSTALLATION
STEP 4: REMOVE THE KICK PLATE
1. Remove the two kick plate screws with a Phillips screwdriver, then remove the
kick plate.
STEP 5: INSTALL TO POWER
Turn off the electricity to the dishwasher’s electrical circuit.
Make sure that the electrical power is turned off at the source.
UP
DOWN
13
Step 4: Remove the toekick
• Remove the two toekick screws with a Phillips screwdriver, then remove the toekick.
Step 5: Install to power
Turn off the electricity to the dishwasher’s electrical circuit.
Make sure that the electrical power is turned off at the source.
Power cord
1
Remove the junction box cover on the front right of the dishwasher.
2
Make sure that the junction box’s electrical wires are pulled inside of the junction box.
3
Remove the lock nut from the strain relief, then push the strain relief into the round opening of the junction box.
4
Install the lock nut on the strain relief from inside the junction box.
5
Insert the ends of the power cord’s electrical wires into the junction box through the strain relief.
6
Connect the incoming white (or ribbed) wire to the dishwasher’s white wire, the black (or smooth) wire to the
dishwasher’s black wire, and the ground wire to the dishwasher’s green wire. Use cUL/UL listed wire nuts of the
appropriate size.
7
Tighten the strain relief screws and lock nut to stabilize the power cord’s electrical wires, then make sure that all of the
connections are secure.
You’ll need:
Warning:
•If your house wiring is not 2-wire with a ground, a ground must be provided by the installer.
•If your house wiring is aluminum, be sure to use cUL/UL Listed anti-oxidant compound and aluminum-to-copper
connectors.
Phillips screwdriver
Adjustable wrench
WARNING
If your house wiring is not 2-wire with a ground, a ground must be
provided by the installer.
If your house wiring is aluminum, be sure to use cUL/UL Listed anti-
oxidant compound and aluminum-to-copper connectors.
Electrical Connection
INSTALLATION
Power cord
1. Remove the junction box cover on the front right of the dishwasher.
2. Make sure that the junction box’s electrical wires are pulled inside of the junction
box.
3. Remove the lock nut from the strain relief, then push the strain relief into the round
opening of the junction box.
4. Install the lock nut on the strain relief from inside the junction box.
5. Insert the ends of the power cord’s electrical wires into the junction box through
the strain relief.
6. Connect the incoming white (or ribbed) wire to the dishwasher’s white wire, the
black (or smooth) wire to the dishwasher’s black wire, and the ground wire to the
dishwasher’s green wire. Use cUL/UL listed wire nuts of the appropriate size.
7. Tighten the strain relief screws and lock nut to stabilize the power cord’s electrical
wires, then make sure that all of the connections are secure.
8. Replace the junction box cover on the right front of the dishwasher. Be sure that
the wires are not pinched under the cover.
Note:
If you have trouble replacing the junction box cover, loosen the
screws on the strain relief.
YOU’LL NEED
• Adjustable wrench
• Philips screwdriver
• Power cord
• Phillips screwdriver
• Strain relief (for electrical connection)
• Three wire nuts (UL listed)
