Zline BLISS BLS-SHS, Installation Manual And User'S Manual

Page: 7 / 84

1
PRIOR TO INSTALLATION
• Make sure that the cold and hot water lines are turned off.
• Wrap all threaded connections with Teflon tape. Always wrap in a clockwise
direction.
• Cover your drain to avoid losing parts.
• Do not disassemble the main system body, as it has been installed and
commissioned correctly and precisely before delivery to the factory.
• To keep the system from jamming, flush the water pipe before installation.
Operating conditions: Working pressure at 0.05-1.0 MPa (including cold and hot
water pressure) with applicable water temperature: 39.2°F - 194°F.
CARE AND MAINTENANCE
To keep the product clean and shining, follow the steps below:
1. Rinse clean with water and dry with a soft cloth.
2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners.
3. Do not use cloth with a coarse surface.
4. Unscrew the aerator and clean when necessary.
• If soldering the water connections when installing the system, remove the
O-rings, cartridges, and washers before applying any heat.
• Protect your eyes when cutting or soldering.
• Do not over tighten screws/nuts. Finger tighten, then use a wrench/screwdriver
to tighten the fixing screw/nut until snug.
SAFETY INSTRUCTIONS
Gener
al Safet
y