BR1200 User Manual
P a g e
|
38
z
Verification Mode:
The device supports 15 combinations verification modes. According to
the need to choose, can choose as: password/fingerprint/badge, fingerprint only, user ID only,
password, badge only, fingerprint/password, fingerprint/badge, user ID + fingerprint,
finge password, finge badge, finge pa badge, pa
badge, password/badge, user ID + finge password and finge (badge / user ID).
#
Remarks:
1. “/” means “or”. “+” means “and”.
2. In a combined verification mode, the corresponding verification information must be
registered first. For example: When User A registers fingerprint only, and the [Verification
Mode] is set as “Pa Badge”, User A will not pass verification.
z
Door available time period:
It is used to limit the time the user can open the door.
z
NO Time Period:
It is used to set a time period for Normally Open, so that the door is always
unlocked during this period.
z
Use as master:
While configuring the master and slave devices, you may set the state of the
master as
Out
or
In
.
Out:
A record of verification on the master device is a check-out record.
In:
A record of verification on the master device is a check-in record.
z
Auxiliary input configuration:
To set the
Aux output/Lock open time
and
Aux Output
type
for the device with auxiliary connector.
Aux Output type
includes
None
,
Trigger door
open
,
Trigger Alarm
, and
Trigger Door open and Alarm
.
z
Verify mode by RS485:
It is the verification mode used by the device when it is the master
unit. This option will be displayed only if RS485 reader function is enabled.
z
Speaker Alarm:
When the
[Speaker Alarm]
is enabled, the speaker will sound an alarm when
the device is being dismantled.
z
Reset Access Setting:
It will reset the parameters of door lock delay, door sensor delay, door
sensor type, door alarm delay, retry times to alarm, NC time period, NO time period, valid
holidays, speaker alarm, Anti-Passback direction, device status, duress function, alarm on 1:1
match, alarm on 1: N match, alarm on password and alarm delay. However, the content of the
Access Data Deletion in
[Data Mgt.]
will not be affected.
