BioSense Series Network Video Recorder User Manual
P a g e
| 81
Copyright©2023 ZKTECO CO., LTD. All rights reserved.
PTZ’s “+” terminal should be connected to DVR’s interface “A”.
PTZ’s “-” terminal should be connected to DVR’s interface “B”.
1.
PTZ’s video output interface should be connected to DVR’s video in interface.
2.
Power the PTZ.
3.
Choose the correct PTZ protocol in menu
CONFIG > CHANNEL > P/T/Z
.
Note:
120Ω resistors should be paralleled at the remote terminal of interface A and B to reduce the
distortion of signal if a larger number of PTZs are connected.
14.6.
Basic Operation Guide
14.6.1.
Power On
Install the DVR correctly (as above) and connect to the power. DVR’s LED lights will be on and it will boot
automatically.
DVR can detect any connected hardware automatically (cameras, monitors, etc.), it could last for about 20
Seconds. You will hear “beep” sound if the whole process is completed. DVR will set itself to multi-screen,
real-time surveillance mode and start recording video according to the plan you have set.
14.6.2.
Power Off
There are two ways to shut down the DVR:
1.
Right click
Main Menu > Shut Down
.
2.
If there is a power button on the front or back panel, press the button to shut down.
14.6.3.
Log In
Right click the mouse and select log in from the menu. Type in username and password.
Note:
The default administrator account is admin and the default password is 123456. Users can modify
the password by themselves. The administrator can add, delete and modify other accounts’ parameters.
•
Password:
If you enter error password more than 6 times, the DVR will beep, and the account will be
locked. Shut down the device and reboot it or leave the device for about 5 minutes, the account will
