Zirkon zahn zirkonofen 600/V3, Operator And Maintenance Manual

Page: 11 / 40

11 11 CHAPTER
SAFETY / RESIDUAL RISKS
MANUFACTURER
Zirkonzahn S.r.l., Headquarters Italy – 39030 Gais – BZ, is the manufacturer of the Zirkonofen
600/V3 sintering furnace and is referred throughout the Operator’s and Maintenance Manual as
Zirkonzahn.
INFORMATION
This Operator’s and Maintenance Manual is an integral part of the Zirkonofen 600/V3 sintering
furnace and must be kept in a place known to the operator and easily and immediately accessible at
all times. Only adequately trained personnel must handle the Zirkonofen 600/V3 sintering furnace.
This Operator’s and Maintenance Manual covers all you need to know for safe use and
maintenance of the Zirkonofen 600/V3 sintering furnace produced by Zirkonzahn S.r.l.
This manual is subject to amendments at Zirkonzahn's sole discretion in the event of technical
further development.
SERVICE
If any points of these instructions remain unclear or if indications, instructions, safety
instructions or technical explanations have not been fully understood, do not hesitate to
contact Zirkonzahn headquarters (phone +39 0474 066 660 or e-mail: info@zirkonzahn.com)
QTVJGUGTXKEGEGPVGTUURGEKſGFKP[QWTOCKPVGPCPEGEQPVTCEV
SAFETY / RESIDUAL
RISKS