SET UP CONTACT INFO
1.
Enter your name.
2.
Type your primary email address for notifications.
Up to 5 email addresses can be linked to each detector.
3.
To add another email, click or tap . To remove
an email, click or tap .
4.
Click or tap
to complete setup, then close the
browser window.
5.
A confirmation email will be sent to all
addresses entered. Check your email(s) to verify that
confirmation was received. If you don’t see the email:
• Check your junk or spam folder.
• Check your Wi-Fi connection.
• Repeat the setup steps, ensuring all user information
was entered correctly.
If notifications are still not received, visit zircon.com/
setup/leakalertx for the latest product
information / updates.
If your router’s settings change:
If your
router is reset or replaced, or if the password
is changed, the detector must be reconfigured to
match the router. While the detector will still emit
an audio and visual alert, it will be unable to
send email notifications. The detector will chirp if
disconnected from the router.
TEST YOUR DETECTOR
To test your detector, place the unit in its
desired location, wet a finger, and place it on the
metal Sensing Contacts.
A beep will repeat, and the LEDs will flash. To stop
the alarm, dry the contacts.
Verify that you also received an email notification to
all configured email addresses.
John Smith
Wi-Fi
DEVICE
DONE
1
2
3
CONTACT
Alert Email Address
If you don’t see the email(s):
• Check your junk or spam folder.
• Check your Wi-Fi connection.
• Repeat the setup steps, ensuring all user information
was entered correctly.
If notifications still are not received, visit zircon.com/
setup/leakalertx for the latest product
information / updates.
PLACE YOUR DETECTOR
The Leak Alert
X Smart Water Detector can be placed
on any surface, mounted onto a wall with a screw or
nail, or affixed to a magnetic surface with its magnetic
body as long as the metal Sensing Contacts at the end
of the cable are able to lay flat against the surface
to be detected. Water must make contact with both
metal Sensing Contacts to alert of a leak and sound
the alarm. The cable is 9.8 ft (3 m) long, allowing
discreet leak detection in areas not always accessible
with a standard detector.
The detector only detects
water if it comes into
contact with both
Sensing Contacts.
If the area floods, an alarm
will sound and red LEDs
will flash for the life of
the battery, or until the
detector is deactivated.
An email notification will be
sent every 10 minutes for the first hour after
leak detection, and once every hour afterward
for the life of the battery.
SOFTWARE UPDATES
Zircon periodically releases new versions of software.
1.
To update the detector software, access the
interface as described starting under “CONFIGURE
DETECTOR TO WI-FI.”
2.
If a red dot appears above the ,
this indicates that an update is available.
Click or tap to access the HELP screen.
3.
Click or tap YES to update the software.
REGISTER YOUR DETECTOR
We strongly recommend registering your detector.
You will receive the latest product information,
including updated instructions, links to helpful videos
and notifications of new software updates. To register,
go to www.zircon.com.
DETECTOR MUST BE WITHIN
RANGE OF ROUTER.
5 EN
6
EN
