26
ZIPPIE SALSA R
2
/ ZIPPIE SALSA M
2
Rev.2.0
PART 2
1. Loosen the 4.0 mm arm pad angle pivot bolts (A-B) on
both armrests. (Fig.5.30).
2. Loosen the 6mm rotation bolts on both armrests (B).
Use the 5.0 mm fine height adjustment screw (C) to
finish fine tuning the height. Turn counter-clockwise to
increase height or clockwise to lower, (Fig.5.31).
3. Tilt both arm pads down, (or up in the case of a
lowered armrest), until the arm pads are in the
preferred angle. Check to see if the height is correct,
Retighten both armrest pivot bolts, (A). (Fig.5.33).
4. Refer to 2. for fine adjustment.
5. Retighten the 6mm rotation bolts on both armrests,
(B). (Fig.5.32).
6. Use 20 N/m or 177 in/lb of torque.
7. Retighten both arm pad angle pivot bolts (A-B). Use
10 N/m or 88.5 in/lb of torque for both sets of bolts,
(Fig.5.33).
NOTE:
Refer to the Standard Configuration Chart for
backrest angle/armrest height settings, (Fig.34).
WARNING!
Both sets of bolts should be checked periodically for
tightness. If loose the arm pad could slip down when
pressed.
Fig. 5.31
B
C
Fig. 5.32
B
Fig. 5.30
A
B
Fig. 5.33
B
A
