18
ZIPPIE SALSA R
2
/ ZIPPIE SALSA M
2
Rev.2.0
4.31 Lap belt (Standard Seat)
The lap belt kit. (Fig. 4.14).
Fastening the lap strap:
Insert the 3 prong male buckle into the female buckle until
a click is heard
(Fig. 4.15)
To fit the lap strap.
• Place the strap loosely across the seat with the buckle
closed.. (Fig. 4.16)
• Pass the other ends of the strap through the gap
between the backrest posts and the backrest
upholstery as shown. (Fig. 4.17)
• Ensure that the adjusters & buckles can be accessed
& the strap is not twisted. Fit the eyelet over the
rearmost bolt. Fit the plain washer, sprung washer &
nut. Tighten with a 13.0 mm spanner. Repeat for the
other side. (Fig. 4.18)
• Ensure that the lap strap is tight enough to provide
comfortable support. A simple measure is to keep
a hands thickness between the body and lap strap.
For safety, check the tension on the lap strap at least
once day. (Fig. 4.19)
• Generally, the lap belt should be fixed so that the
straps sit at an angle of approximately 45° (Fig. 4.20),
and when correctly adjusted should not allow the user
to slip down in the seat.
WARNING!
• Ensure that the lap belt is secured and correctly
adjusted before use.
• An incorrectly fitted/adjusted lap belt could allow the
user to slip down, potentially causing serious injury.
• Inspect the lap belt at regular intervals for any signs of
fray or damage and replace as necessary.
• When servicing, check for correct operation of the
release buckle and for any signs of wear on the
material or plastic brackets.
Fig. 4.14
Fig. 4.15
Fig. 4.16
Fig. 4.17
Fig. 4.18
Fig. 4.19
Fig. 4.20
