OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
38
ZI-HAEK15000
7.
engine tank volume see technical data. Fill the tank
only up to 1.5 cm below the edge of the filler neck so
that the fuel has room to expand.
8.
NOTE: If necessary, refill with gasoline of the appropri-
ate octane rating (RON 95).
9.
Screw the filler cap back on.
10.
Wipe off any fuel residues and wait until the vapors
have evaporated.
15
OPERATION
Only operate the machine when it is in perfect condition. A visual inspection of the machine must be carried
out before each operation. Safety devices and operating elements must be checked carefully. Check screw
connections for damage and tight fit as well as the condition of the cutting blades
15.1
Information on initial start-up
N OTE
Note that the machine is delivered without engine oil and fuel.
Ensure that these operat-
ing fluids are topped up before initial start-up
. CAUTION: Machine will not start until en-
gine oil is topped up to the upper limit Oil starvation!!
15.1.1
Test run initial start-up
•
Allow the engine to idel for about 3 minutes
•
Pay attention to abnormal noises
•
Pay attention to the exhaust gases (black or white smoke)
15.1.2
Notes for the first 20 operating hours
To maximize the lifespan of our machine you should follow these points
•
Change the engine oil after the first 20 operating hours.
15.2
Operation
15.2.1
Start Engine
Start the engine when you have mounted your machine according to the instructions and it is filled with the
fuel and oil:
1.
Move the choke lever to the „Closed“ position. If the engine
is hot, closing the chike is not necessary
2.
Turn ON-OFF-Switch to "ON" position.
3.
Open the fuel shut-off valve.
4.
Position the throttle lever in the idle position
