CLEANING, MAINTENANCE, STORAGE, DISPOSAL
34
ZI-STE3000IV
13.7
AC Operation
1.
Verify that the green indicator light (running) is on after starting the engine. This indicates that
the machine is working properly.
2.
Check that the ON-OFF switch of the electrical devices to be used is set to „OFF“.
3.
Connect the device to the AC-socket.
4.
Start the device.
NOTE:
When connecting several devices, connect them in decreasing order of their kW consump-
tion!
13.8
DC Operation
12V charging function for batteries: Before operation, observe the instructions and notes of the battery man-
ufacturer. If the indicated charging currents/voltages of the machine are not permissible or not known for
your battery, charge the battery via a battery charger to avoid damage.
1.
During the direct current operation, switch off the ECO-
mode. To do this, set the switch of the ECO-mode to the "0"
position.
2.
First connected the charging cable to the DC-connection of
the machine.
3.
Then link the charging cable to the connectors of the battery.
4.
Start the machine.
NOTE:
•
Do not charge built-in batteries.
•
Do not change the polarity of the charging cable, otherwise
serious results such as damage of the machine and the bat-
tery will be caused.
•
When disconnecting the charging cable, start with the bat-
tery first.
•
A battery contains acid (electrolyte). Any contact with the skin
or eyes will cause severe burns. Use a mask, eye protection and
protective clothing
NOTE:
AC and DC sockets can be used simultaneously.
An overload of the DC circuit can cause the circuit breaker 12V
(3) to be activated (the pressure spring of the switch pops up). If
this happens, look for possible causes.
In order to resume operation, press the DC-circuit breaker 12V (3).
14
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
WARN IN G
Always stop the machine and let it cool down before carrying out any maintenance work
and secure it against unintentional commissioning.
WARNING:
Lack of maintenance or improper maintenance and repair before using the machine can result in serious
injury or death! Take therefore the safety rules, operating and maintenance instructions very seriously.
Re-
pairs only by qualified staff!
NOTE:
Prevent unintentional commissioning of the machine by interrupting the fuel supply (fuel tap in po-
sition "OFF") as well as interrupting the ignition spark (remove spark plug cap of spark plug).
14.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe operation.
NOTE:
The use of solvents, aggressive chemicals or scouring agents can cause damage to the plastic
parts of the machine!
Thus, when cleaning, use only water and, if necessary, mild detergents.
•
We recommend cleaning the machine immediately after each use.
•
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
•
Wipe the equipment with a moist cloth and some soft soap or blow it with compressed air at
low pressure.
•
Take care that any water enters the interior of the machine.
