TROUBLE SHOOTING
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
29
ZI-PTKS85
14.2
Maintenance plan
After each workshift:
Remove cutting chips and dust from the machine (especially from the interior of the
machine!)
14.3
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
N O T I C E
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.4
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Possible cause
Solution
Machine did not start
ON-OFF-switch defective
Change the ON-OFF-switch.
Poor cutting result
Wrong saw blade
Wrong cutting speed
setting
Change saw blade
Adjust cutting speed
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION TO
THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix the
problem.
