ZIPPER MASCHINEN ZI-CRM40V-AKKU, User Manual

Page: 19 / 37

SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at  19
ZI-CRM40V-AKKU
 Keep your hands and feet away from moving machine parts and always ensure a secure
stand when working.
 Remove the setting tool from the machine before switching on.
 Never leave the running machine unattended (always switch the machine off before
leaving).
 Ensure that unauthorised persons maintain an appropriate safety distance from the
machine, and in particular keep children away from the machine.
 The machine may only be operated, maintained or repaired by persons who are familiar
with it and who have been informed of the risks involved in this work.
 Always wear suitable personal protective equipment (hearing protection, safety shoes
etc.)!
 Do not work on the machine if you are tired, unconcentrated or under the influence of
medicines, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).
 Only use spare parts and accessories recommended by Zipper machines.
11.4 Special safety instructions for the operation the machine
 Wear solid and non-slip shoes when working. Slips/stumps/falls are a major cause of
serious or fatal injuries.
 Caution on uneven work surfaces and on work surfaces with slopes - never mow on slopes
that are too steep
 Ensure that a safe distance is always maintained and wear shoes with non-slip soles and
long trousers. Always work across the slope.
 Exercise particular care when walking backwards and pulling. There is a risk of tripping!
Always work at walking pace, never run!
 Before each use, check the operational safety of the machine (tight fit of the cutting tool,
correct function).
 Before starting, after failure or impact, check the machine and make sure that it is in good
condition
 Check the area to be worked on for objects that can be caught and thrown away by the
machine and remove them. (stones, branches etc.).
 Take special care when working near swimming pools or garden ponds!
 Never use the machine in rain or in a damp, wet environment
 Before carrying out maintenance or adjustment work, remove the battery from the battery
compartment and the safety key (if present) of the machine!
 Never reach into the mower during operation.
 Make sure that you do not get under the cutting tool!
 Switch off the machine if the machine has to be tilted over a surface other than grass for
transport and if the machine is transported to and from a working site.
11.5 Safety instrcution for battery and charger
CHARGER:
 The charger is only suitable for charging the batteries that match the charger. Charging
other batteries is not permitted (suitable batteries are described in the operating manual).
 Never use the charger in a damp or wet environment.
 Only disconnect cable connections by pulling the plug. Pulling on the cable could damage
the cable and plug and electrical safety would no longer be guaranteed.
 Never use the charger if the cable, plug or the device itself is damaged by external
influences. Then take the charger to the next authorised workshop.
 Prevent the cooling function of the unit from being impeded by covering the cooling slots.
 Do not operate the unit near heat sources.
 Do not use an extension cable to connect the charger to the power supply unit of the
charging station.
 Do not place any metal objects in the area of the charging contacts of the charging
station.
 Never open the charger. In the event of a fault, contact a qualified workshop.