MAINTENANCE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
25
ZI-MOS145JAK
14
MAINTENANCE
ATTENTION
No cleaning, upkeep, checks or maintenance when machine is running
Shut off the machine and let it cool down before start servicing!
The machine does not require intense maintenance. However, to ensure a long lifespan, we strongly
recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists! Use original ZIPPER parts only!
Ware safety gloves if you are work on the cutting tool!
Damaged cutting tools may never be straightened or welded!
NOTICE
Only a properly maintained equipment may be a satisfactory tool. Care and maintenance deficiencies
can cause unpredictable accidents and injuries.
Repairs should be performed only by authorized service centers.
Improper operation may damage the equipment or endanger your safety.
Controls for the maintenance of the machine
Loose or lost screws, nuts, bolts
Regularly prior to each operation
Damage of any part of the machine
Regularly prior to each operation
Damage of cutting tools
Regularly prior to each operation
Fuel tank of tightness
Regularly prior to each operation
Machine cleaning
Regularly after operation
Cleaning spark plug
Every 25 working hours
Cleaning air filter
Every 20-30 working hours
14.1
Cleaning
Clean the machine and the working attachment from soil, dust, grass, chips, and small twigs, etc.
Clean the machine housing with a wet cloth and a mild detergent.
NOTE
Do not use cleaning agents or solvents; these could attack the plastic parts of the
machine!
Put on all coatless flats a thin coat of oil.
14.1.1
Cleaning the air filter
The air filter has to be cleaned approx. every 20-30 working hours. This may vary depending on the
air quality of your working area.
Polluted and clogged air filters reduce the engine output by far and may lead to engine damage.
To clean the air filter just remove the black air filter cover and take the filter out. Wash it in a mild
water based solvent, squeeze it out, let it dry and put it back again.
14.1.2
Check the spark plug
Clean of debris with metal brush.
Check spark plugs match of 0.6-0.7mm
14.1.3
Carburettor
NOTE
Carburetor adjustments should be carried out only by trained specialist personnel!
