ERRORE. LO STILE NON E DEFINITO.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
31
ZI-COM50-2V5E / ZI-COM50-2V510E
15
TROUBLE SHOOTING
Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Possible cause
Solution
Pressure can no
longer be stored
•
Valve seals broken
•
Replace the seals
Engine overheats
•
low oil level
•
dirty air filter
•
Refill oil
•
Clean or replace the air filter
Compressor runs
but produces no
pressure
•
Clogged air filters
•
Defective seals
•
Defective valves in the cylinder
head.
•
Clean or replace the old air filter
•
Replace the seals
•
Replace the valves
Engine will not start
•
No power supply
•
Overload protection activated
•
Check the connection to an existing
electrical grid.
•
Let the engine cool down and then
pull the red pressure switch (on /
off)
After reaching the
escapes cut-off
pressure
Compressed air
through the relief
valve und Pressure
switch to reach the
starting pressure
•
Leaking or defective check valve
•
Check valve is damaged
•
Clean or replace check valve insert
•
Replace check valve
Compressor on
frequently
•
Very much condensate in the
pressure boiler
•
Overload compressor
•
Drain condensate
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
