ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
24
ZI-MOS40V-AKKU
CHARGER:
•
The charger is designed exclusively to charge the lithium - ion battery of this
machine. Charging other batteries is not permitted.
•
Never use the charger in a damp or wet environment
•
Disconnect cable connections only by pulling the plug. Pulling on the cable could
damage the cable and plug and electrical safety would no longer be guaranteed.
•
Never use the charger if the cord, plug or the appliance itself is damaged by
external influences. Attach the charger then to the next workshop.
•
Make sure that the cooling function of the device is impeded by covering the
ventilation slots.
•
Do not use the unit near heat sources
•
Do not use extension cord to supply power to the charging station
•
Do not place metal objects in the area of the charging contacts of the charger.
•
Do not open the charger. In case of failure, contact a specialist workshop.
•
Use to recharge your battery only with the original charger. Use of other
chargers defects may occur or fire hazard.
BATTERY:
•
Improper use or the use of damaged batteries leaking vapors. Run to fresh air
and seek medical attention in case of complaints. The vapors can irritate the
respiratory tract.
•
FIRE HAZARD! Never charge batteries near acids and flammable materials.
•
Charge the battery only in an ambient temperature between 0 ° C to +40 ° C.
Leave to cool down after heavy load.
•
EXPLOSIVE! Protect the battery from heat and fire.
•
Use the battery only in an ambient temperature between 0 ° C to +45 ° C.
•
SHORT CIRCUIT! For disposal, transport or storage, the battery must (plastic
bag, box) or the contacts are packed must be taped.
•
Never open the battery
11.3
Remaining risk factors
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
•
Risk of injury due to noise:
Working for a long time can damage your hearing if you do not have a very good hearing protection.
•
Risk of injury due to the working area:
Solid objects, stones, metal parts, or the like can be thrown out!
•
Risk to the hands or fingers:
Do not grab in the cutting tool while it is rotating.
•
Risk of injury due to pick up and roll up:
Wires and cords can be detected by the cutting tool and can damage the machine and can cause
injuries. Unplug battery and safety switch (if equipped) before removing the deposits!
•
Risk of injury due to vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
•
Rotating parts
Be rotating parts (blades) mounted incorrectly, this can lead to serious accidents. Check before starting
work, the cutting blade for tight fit.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience
