HydroTap Installation and Operating Instructions
Page 15 of 20
The Zip HydroTap notifies when filter replacement is due. The default setting is 6000 Ltrs,
but this can be set in increments of 1000Ltr from 1000Ltr to 10000Ltrs. When a filter
change is due, the Change Filter light will flash white once a minute and remain so until
reset. A filter status light is located between the Red and Blue Lights on the tap head
assembly.
Depending on local water quality conditions and usage, the filter may require changing
anywhere from 1000 Ltrs to 10000 Ltrs. You may also need to replace the filter if you notice
unpleasant odours or tastes.
Some water may drip from the filter head (socket) during replacement. Keep a bucket and
towel handy to catch drips and mop up any spills.
To change the Filter:
1. Scroll through the screen menu to “Filter Flush Off” this isolates the water supply.
2. Open the door on the left
3. Relieve system pressure via the filter flush stop cock, a quick open and close will do.
Use the bucket to catch the discharge.
4. Grasp filter cartridge and twist right to left one quarter turn until it stops.
5. Ease cartridge downwards to detach it from the filter head (socket).
6. Do not tilt the cartridge as dirty water may spill from it if tilted.
7. Unpack replacement cartridge and write today’s date where shown on the label.
8. Avoid touching the filter “O” rings and filter opening as this may cause bacterial
contamination of the cartridge.
9. Align cartridge tabs with the slots on the under-side of the filter head.
10. Slide cartridge upward into head and rotate left to right until it stops.
11. Locate the filter flush hose situated behind the filter cartridge and run to a container
ready for flushing. Open the flush hose tap lever. On the control panel press Adjust
>
, this will start the water flushing the cartridge. Allow at least 7.5 Ltrs of water to run
through to activate the filter and then press Adjust
>
to stop the flow.
12. Isolate the filter flush stop cock and re-fit behind the filter cartridge.
13. Wipe up any spills and dispose of spent filter cartridge and packaging thoughtfully.
14. Scroll through the menu to “Litres Filtered”, press Adjust
>
to reset litre counter. Press
Adjust
>
and it asks “are you sure”. Press Adjust
>
again to lock in the command.
15. Scroll through the menu to “Filter Used (Days)”, press Adjust
>
to reset the timer. Press
Adjust
>
and it asks “are you sure”. Press Adjust
>
again to lock in the command.
After approx 10 seconds it will default to the selected mode.
16. Close the door to secure the appliance.
Replacing the Filter
Setting the Energy Saver Timer
Mode Plus Button
Mode Minus Button
Plus Adjust Button
Minus Adjust Button
Note:
Mode buttons
change the
screen options
Adjust buttons
select the
screen options
