HydroTap Installation and Operating Instructions_Commercial_BCH 4in1_BH 3in1_October 2012_V1.05
Page 18 of 24
Press either Mode
<
or Mode < button until “Litres Filtered” is displayed.
Press
<
Adjust once and “Reset Counter” will be displayed, press
<
Adjust
button once and “Are You Sure” will be displayed.
Press
<
Adjust once and “Litres Filtered” will be reset to 0.
Activating Sleep Mode
This mode allows the HydroTap to go into Energy Saving mode. In this mode
the unit will go to “sleep” after a predetermined period of inactivity.
Press either Mode
>
or Mode
>
button until “Sleep Mode” is displayed.
Press
>
Adjust once to select.
Option 1:
Sleep to 65ºC after 2 hours of NO USE
Press
>
Adjust once to select.
Option 2:
Auto OFF after 2 hours of NO USE.
When the period of inactivity passes, the display will show “Sleep Mode”.
During the “Sleep Mode” the Red LED on top of the tap lever will flash slowly.
Sleep to OFF means the Boiling and Chilled circuits will be switched OFF.
De-Activating Sleep Mode:
Momentarily operate the Hot lever on the HydroTap and then allow sufficient
time for the water to reach the set temperature.
Activating On / Off Mode
Press the Mode
<
or Mode < button until “Monday On” is displayed. To set
the time for the unit to turn on press
<
Adjust button until required time is
reached.
To set the time for the unit to turn Off press Mode
<
button once and “Monday
Off” will be displayed. Now press
<
Adjust until required time is reached.
If each individual day is to have an “On / Off” time, these steps need to be
repeated for each day and for each On / Off time.
Note:
The HydroTap may be temporarily activated during the On / Off Mode. By
operating the levers, the unit will go into normal operation and then remain in
an “ON” cycle, until the next “OFF” cycle.
Operating the Mixer tap will not De-Activate the sleep mode or the energy
saver On/Off timer mode.
Setting the Energy Saver Timer
(continued)
Auxiliary Fan Attachment
The HydroTap is equipped with an auxiliary fan connection point on the rear
panel close to the cold water inlet / flex and plug area. The fan kit is available
as a spare part. The fan operates in parallel with the Condenser fan helping
to remove heat from the cupboard space. This fan should be purchased and
connected to the HydroTap if the airfow characteristics of the cupboard space
are inadequate for the effective removal of hot air, thereby adversely affecting
the operation of the HydroTap.
The fan can be installed so that it extracts air from, or forces air into the
cupboard space, whichever is the most effective for your installation.
Application of the fan is of paramount importance in situations where the
cupboard space reaches temperatures greater than 35ºC.
The exhaust fan kit must be fitted, when supplied with the appliance.
Note: 200/175 model is supplied with the auxiliary fan kit.
Auxiliary fan
connection
Cold water
connection
Electrical
connections
