Instructions. V1.01
Page 4
JUNE / 2013
CAUTIONS
• Children should be supervised in order to make sure that they do not play with the appliance.
• The water vessel is intended for an open outlet and should never be subject to greater
than atmospheric pressure.
• The inlet control valve should not be subject to pressure exceeding 0.35 MPa (3.5bar).
• The appliance must only be used when correctly installed and in perfect working order.
• The appliance must be installed in a frost-free room and must never be exposed to frost.
•
The appliance must be completely filled with water before being switched on.
•
THE HOT WATER SHOULD BE DELIVERED FROM THE OPEN OUTLET SPOUT SUPPLIED OR A
ZIP APPROVED OPEN OUTLET TAP FITTING THAT REMAINS PERMANENTLY OPEN TO ALLOW
FOR EXPANSION THAT OCCURS DURING THE HEATING CYCLE. UNDER NO CIRCUMSTANCES
SHOULD THE SPOUT OR OUTLET BE CONNECTED TO A TAP WHICH IS CAPABLE OF BEING
CLOSED.
• The Zip Tudor II and Contract II is intended for connection to mains supply only. In any other
case please contact Zip on 0845 6 005 005 for advice.
•
Zip Heaters (UK) Ltd cannot be held liable for any damages caused by failure to
observe these instructions.
• It is recommended that an
HE45004
Water Block is fitted in the water supply line to
minimise the potential damage in the event of any leakage.
Packed Contents:
Please check that the items below have been supplied in the Heater Unit package.
Outlet Spout
x1(except UB models)
Wall Bracket
x1
Control Valve
x1 (except UB models)
Fixing Screws
x2
Rawlplugs
x2
Accessories:
Only Zip approved open outlet accessories should be used, the following are available.
HE45004 Water Block (for both overbasin and underbasin models)
Overbasin TS/1 Telescopic Spout 350-600mm.
Underbasin UB/1 Monobloc Mixer Tap.
UB/6 Single Lever Basin Tap.
UB/7 Single Lever Sink Tap.
