Assembling the Device
6
Page 11
Note:
Make sure that the power switch on the device is set to "0".
Assembling
mounting bracket
Install the 4 mounting brackets including castors (1) on the bottom of the unit.
Assembling
supporting arm
Assembling
applicator cable
Connecting the
power cable
Slide the supporting arm (4) into the connection for the supporting arm (2).
Bolt the applicator cable (4.1) to the cable connection of the applicator cable
(3).
Connect the power cable to the provided socket (8) on the unit, connect the
cable to the mains.
Note:
The device may only be connected to power outlets with a properly grounded
contact.
Note:
After completion of the assembly, check again to see whether the supporting
arm connection is properly inserted into the connector.
Check that the applicator cable is properly connected to the connector.
The device may only be operated when the applicator cable has been properly
connected. Otherwise a risk to people and environment or damage the device
may occur.
Switching on the
device
Turn on the unit with the mains switch (9).
Switching off the
device
The device is switched off using the power switch (9).
To completely disconnect the device (all-pole) from the mains, the power cord
must be disconnected.
Caution
!
All cables must be protected against twisting or other mechanical damage.
Summary of Contents for ThermoPro
Page 1: ...User Manual ThermoPro USA ...
