6
4
Personnel qualification
Installation, commissioning and maintenance may only be performed by trained specialists. These persons must have read
and understood the installation and operating instructions in full.
5 Product description
5.1 Type plate
A type plate is attached to the housing of the product.
XXX
XX-XXXXXX
am
an
The article number and the confirmation number are shown on the type
plate.
am
Article number
an
Confirmation number
6 Functional description
The product has a double-acting pneumatic rotor cylinder.
Alternating ventilation sets the gripper jaws in motion.
The movement generated in this process is transferred to the gripper jaws by kinematics, producing the gripper jaw
movement.
7 Technical data
INFORMATION
►
You can find the information in the technical data sheet on our website.
This data varies within the series, depending on the specific design.
►
Please contact Zimmer Customer Service if you have any questions.
8 Accessories/scope of delivery
INFORMATION
If any accessories not sold or authorized by Zimmer GmbH are used, the function of the product cannot be
guaranteed. Zimmer GmbH accessories are specifically tailored to the individual products.
►
For optional accessories and those included in the scope of delivery, refer to our website.
9 Transportation/storage/preservation
►
Transport and storage of the product must be done only with the original packaging.
►
If the product has already been installed on the superordinate machine unit, care must be taken during transport to
ensure that no unexpected movements can occur.
►
Before commissioning the product and after transport, check all power and communication connections as well as
all mechanical connections.
►
If the product is stored for an extended period, the following points are to be observed:
►
Keep the storage location as dust-free and dry as possible.
►
Avoid temperature fluctuations.
►
Avoid wind/drafts/water condensation formation.
►
Pack the product and do not expose it to direct sunlight during storage.
►
Clean all components. There must be no soiling left on the components.
►
Visually inspect all components.
►
Remove all foreign substances.
►
Properly remove potential corrosion spots.
►
Close off unused connections using pressure-resistant closures.
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATION INSTRUCTIONS:
GH6000
DDOC00274 / e
EN / 2023-02-13
Summary of Contents for GH6000
Page 2: ......
