![background image](http://html.mh-extra.com/html/zimmer/gentle-pro/gentle-pro_instructions-for-use-manual_934029016.webp)
Device Set Up
4
Page 5
Note:
Make sure that the power switch on the device is set to "0".
Mains cable
connection
Connect the power cable to the appropriate socket (figure 2: 1) on the device and
connect the cable to the mains.
Note
:
The device may only be connected to power outlets with grounding contact.
Handpiece
connection
Connect the handpiece to the socket on the rear of the SysCart. (Figure 3: 2)
Footswitch
connection
Connect the footswitch (Figure 2: 4) to the socket and place it on the floor.
Switch on the device
Switch on the device with the mains switch.
Filling the water
circuit
See Chapter 12.2
Switch off the device
The unit is switched off via the mains switch. To disconnect the unit completely (all-
pole) from the mains supply, the mains cable has to be removed.
Attention
!
All cables must be protected from disturbance or other mechanical damage.
Attention
!
After horizontal transport or assembly, the device must stand upright for at least 30
minutes prior to being switched on. The compressor might otherwise be damaged.
Note:
The user is responsible for the use of the device. The device may not be modified
without the consent of the manufacturer. The party combining the device and thus
operating a medical system is independently responsible for combining the devices
correctly.
Summary of Contents for Gentle Pro
