Wireless Zdots
®
Single Board Computer Development Kit
QS007504-0410
Page 11 of 19
<ZTP Installed Dir>\ZTP_X.Y.Z_Lib_ZDS\ZTP\SamplePrograms\WLAN-
Demo\WLANDemo.zdsproj>
where
<ZTP Installed Dir>
is the path to the ZTP folder that you set when you
installed the
ZTP_X.Y.Z_Lib_ZDS
. The default location of
<ZTP Installed Dir> is C:\Program Files\ZiLOG.
4. Select
Build
Set Active Configuration
to open the
Select Configuration
dialog
box, and select the RAM configuration.
5. From the
Project
menu in ZDS II, select
Settings
. The
Project Settings
dialog box
appears.
6. In the
Project Settings
dialog box, select the
Debugger
tab. In the
Debugger
tab,
ensure
eZ80F91_WiFi_RAM
option is checked and the correct debug tool is
selected. In this Demo, USB Smart Cable is used as the Debug Tool.
7. Click
OK
to close the
Project Settings
dialog box.
If the ZDS II prompts to
Rebuild the Project
, click
YES
to enable the
configuration on
Project
Settings
.
8. After the successful build, run the Demo application using
Debug
Go
.
This is observed on Hyper Terminal window:
Initializing SPI
Initializing SDIO card
get SYSCLKR=c0000000
set SYSCLKR=c0000003
get SYSCLKR=c0000003
RTL8711_3rdCUT
SYSCTRL : 68 !
EEPROM ID=8711
EEPROM MAC Address = 0-90-23-0-4e-ab
Downloading
FW#
totlen=118300,
img
sz=118200,
hdrsz=100...Done
Firmware Init OK[ZTP ]>
9. Once the
shell
prompt appears, use the
scan
command on the
Hyper Terminal
window and press
Enter
to search the access points (AP) available in the range.
Note: