ZIEHL MS 220 DA, Operating Instructions Manual

Page: 17 / 48

- The plastic cover must point downwards.
- Connect the motor resistor (thermistor) to terminals T1 and T2 of the MS 220 DA. Open jumper 12-37 on the frequency converter and connect
terminal X44/12 on the MS 220 DA with terminal 37 (Safe Stop) on the frequency converter (see Photo 4). Only then can the VLT AutomationDrive
FC 302 be safely shut down in the case of malfunction. The output on terminal X44/12 of the MS 220 DA must always be wired into the chain
on the Safe Stop input on terminal 37 on the frequency converter in order to ensure shutdown of power in case of malfunction.
- Continue the necessary wiring of the MS 220 DA. See connection diagram in section 1.2 .
- Afterwards, remove the gaps for slot „B“ from the deeper frame supplied, and reinsert the frame, terminal cover, and the LCP control unit. (see
Photos 5 or 6)
Illustration 6.5: Photo 5 Illustration 6.6: Photo 6
- Close the device with the cover or with the enclosure cover in order to restore the enclosure to its initial condition.
- Restore the supply voltage to the frequency converter.
Attention! Depending on the programmed parameters, the motor may start after the supply voltage is restored!
- Configure new additional functions in the corresponding parameters.
Attention! The operator or electrical installer is responsible for proper earthing and adherence to all applicable national and local safety
regulations!
6 Install the MS 220 DA Option in the Fre-
quency Converter Motor Protection MS 220 DA
14
MG33V102 - VLT ® is a regisered Danfoss trademark
6