CODE
INFORMATION
WHAT TO DO
e - 0
Temperature within the heater too high.
Cool-down and re-ignite.
f - 0
Power interrupted.
Re-ignite the heater.
e - 1
Faulty thermostat.
Contact your dealer.
f - 1
Faulty burner thermistor.
Contact your dealer.
e - 2
Starting problems.
Contact your dealer.
e - 5
Tipping-over protection.
Re-ignite the heater.
e - 6
Poor burning.
Contact your dealer.
e - 7
Room temperature
If necessary,
above 32°C.
re-ignite the heater.
e - 8
Defective booster.
Contact your dealer.
e - 9
Air filter dirty; or
Clean filter
Fuel pump dirty.
Contact your dealer.
-- : --
Out of fuel.
Refill removable tank.
(& blinking
FUEL-light)
-- : --
Too little ventilation.
Ventilate better.
(& blinking
VENT-light)
Always contact your dealer for any malfunctioning not listed above.
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaningcode
cl:05
running back to
cl:01
. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I
CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are blocked then. If the heater
has already been switched off, the childproof lock also prevents accidental
ignition of the heater.
Activate the childproof lock by pressing the appropriate key
N
and holding it down
for more than 3 seconds. The KEY-LOCK indicator light will light up (Fig. I),
indicating that the childproof lock has been activated. Switch off the childproof lock
by pressing the key
N
and holding it down for more than 3 seconds once again.
J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
Q
key. The SAVE indicator
light will light up (Fig. J). Switch off the function by pressing the SAVE key once
again.
4
48
In case of any
malfunctioning the
information display will
tell you what is the
matter.
I: When the KEY-LOCK
light lights up, the
childproof lock has been
activated.
J: When the SAVE light
lights up, the heater will
automatically switch on
or off in order to remain
within a specified
temperature range.
