40
SkyZhone 1604, 1404, 1204 Hardware Install Guide
1.
Delete the default VLANS. The following commands remove the
default VLANs:
config vlan vlanconfig removeport interface eth0 vlanid 1
config vlan vlanconfig removeport interface eth1 vlanid 1
config vlan vlanconfig removeport interface wlan0 vlanid 1
config vlan vlanconfig removevlan vlanid 1
config vlan vlanconfig removeport interface eth0 vlanid 7
config vlan vlanconfig removeport interface eth1 vlanid 7
config vlan vlanconfig removevlan vlanid 7
2.
Define the new management VLAN. In this example, VLAN 2 is
the management VLAN.
config vlan vlanconfig addvlan vlan_name management vlanid 2
config vlan vlanconfig addport interface eth0 vlanid 2 tagged
config vlan vlanconfig addport interface eth1 vlanid 2 untagged
config vlan portdefaults default-pvid vlanport eth1 pvid 2
3.
Configure the management address. In this example, the device
address is 10.108.14.218.
config if interface brvlan2 ip 10.108.14.218 mask 255.255.255.0
broadcast 10.108.14.255
config if route-add destination default gw-addr 10.108.14.254
4.
Define the data VLAN. In this example, the data VLAN is VLAN
122.
config vlan vlanconfig addvlan vlan_name data vlanid 122
config vlan vlanconfig addport interface wlan0 vlanid 122 tagged
config vlan vlanconfig addport interface eth0 vlanid 122 tagged
config vlan vlanconfig addport interface eth1 vlanid 122 tagged
config admin-tools save running-config
Using the Ethernet interface
The Ethernet port can be used to configure the SkyZhone access point using the
factory default settings. The Ethernet port on the SkyZhone has a default address
