www.scheppach.com
+(49)-08223-4002-99
+(49)-08223-4002-58
13 І 16
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
11. Transport
m
Attention!
Do not transport whilst the electric power tool is run-
ning.
Before transporting the universal tool stand, pull out
the mains plug of the electric power tool mounted on
it! Risk of injury due to electric shock and unexpected
start-up of the electric power tool!
Two people can lift the universal tool stand by its
frame bed in order to move the universal tool stand
within rooms (do not drag it along the ground).
If being transported in a vehicle, remove the electric
power tool first.
Fold up the legs for transport.
Ensure that the load is well secured if transporting
the universal tool stand in a motor vehicle.
8.3 Fitting the workpiece supports (fig. 6-8)
Insert the workpiece support (4) into the receiver (5)
of the frame bed and fasten in place with the star-grip
screws (6).
The width and height of the workpiece supports can
be adjusted with the star-grip screws (3, 3). (fig. 8)
8.4 Fastening your tabletop machine (fig. 7)
Different tabletop machines can be fastened to your
universal tool stand by adjusting the support arms (2)
to the spacing of the mounting holes on your machine.
• Place your tabletop machine (e.g. mitre saw) on the
support arms (2).
• Fasten the tabletop machine with 4 hexagonal
screws (A), 4 washers (B), 4 spring washers (B.1)
and 4 hexagonal nuts (C) on each of the support
arms.
• Tighten the screws after assembly.
• Fasten the support arms (2) with the mounted tab-
letop machine on the universal tool stand, as de-
scribed in point 8.2.
8.5 Using the workpiece stops (fig. 9)
The workpiece supports (4.1) have integrated work-
piece stops (4.2), which can be used to saw multiple
pieces of wood to the same length.
• Loosen the star-grip screw (6) on the desired side
of the universal tool stand and adjust the height of
the workpiece support (4) such that the support
surface (4.2) is at the same height as the workpiece
support of the saw.
• Loosen the star-grip screw (3) to slide the work-
piece support horizontally.
• Set the desired distance between the saw blade
and the stop surface (4.1).
• Lock your setting by tightening the star-grip screws
(3) again.
9. Cleaning, maintenance and storage
m Important!
Before any cleaning or maintenance work, the electri-
cal tool fitted must be switched off and the mains plug
pulled out! Risk of injury!
9.1 Cleaning
• Keep the universal tool stand as free of dust and
dirt as possible. Rub the universal tool stand clean
with a clean cloth or blow it off with compressed air
at low pressure.
• We recommend that you clean the universal tool
stand immediately after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents - they could attack the plastic
parts of the universal tool stand.
9.2 Storage
m
Attention!
Store the universal tool stand only in dry locations that
are inaccessible for unauthorised persons.
