6 Installation (only for specialized and
qualified technicians)
6720871998 (2019/10)
15
– have an exit above the maximum point of the roof
had.
ÿ Ensure good access during maintenance work, respecting the
minimum distances indicated in Fig. 11.
ÿ Install the burnt gas duct so that there are no leaks.
completely eliminated)
Installation (only for specialized and qualified technicians)
Determine the location of the device considering the following
limitations:
ÿ Fix the device on the shoulder blades so that it is in the
Intoxication!
ÿ Install the supplied bushings and clips.
Never place the appliance on the water or gas connections.
Before assembling the fixing points: ÿ ensure
that the water/gas/exhaust connections are secure.
Fig. 11 Minimum distances (cm)
ÿ Open the respective holes (Ø 8mm) respecting the measurements
RECOMMENDATION:
• The device duct must:
If these conditions cannot be guaranteed, another location must
be chosen to admit the air.
Aggressive substances are halogenated hydrocarbons that contain
chlorine or fluorine. These substances are found in solvents, paints,
glues, propellant gases or liquids and household cleaning products.
ÿ Maximum distance from all protruding parts, such as
such as hoses, tubes, etc.
Failure to comply with the requirement below may cause combustion
gases to leak into the appliance installation compartment, resulting
in personal injury or death.
– be inserted into the chimney ring. The external diameter of the
flue must be slightly smaller than the value of the chimney
diameter indicated in the table with dimensions.
ÿ Remove the front of the device (ÿsection 8.1).
DANGER:
– be thermally insulated
Surface temperature
na tab. 5.
Materials damage!
– be vertical (horizontal sections reduced to a minimum or
The maximum surface temperature of the device is below 85 °C.
According to TRGI or TRF, no protective distances are therefore
necessary for flammable materials and built-in furniture. Pay attention
to the different state directives in force.
No special wall protection is required. The wall must be flat and
capable of supporting the weight of the appliance.
tical.
• All devices must be tightly connected to a gas evacuation duct of
suitable size.
5.2 Minimum distances
6.2 Fixing the device
6.1 Device fixing points
6.3 Connection of the combustion gas duct
Machine Translated by Google