Zetor UTILIX HT Series, Operator'S Manual, Page: 16 / 154

Roll over protective structures (ROPS)
ZETOR Tractors are equipped with a frame for the protection of operators.
In the case of cab tractors the frame is incorporated in the cab structure.
The objective of the frame or cab structure is to protect the operator in the event of a roll over and they are
designed to support the entire weight of the tractor in that event.
Each ZETOR ROPS frame or cab structure is designed and has been tested to meet industry and or
Government standards.
Included in these tests were all mounting bases and bolts or other fasteners.
DANGER
For ROPS frames to be effective and protect the operator, the seat belt provided must be worn in
order to keep operators within the ROPS protected area in the event of a roll over. Failure to use the
seat belt can still cause serious injury or death.
On some models the ROPS frame has a fold down feature, which can be used to enter low buildings etc.
Take care when lowering the upper section of the ROPS frame and take extreme care while driving the
tractor with the ROPS frame lowered.
Do not wear the seat belt with the ROPS lowered and please remember that the fold down facility is for
special circumstances only and must not be lowered for general use.
Use of the tractor with the ROPS lowered can cause fatal injuries
As the ROPS frame or cab together with the seat belt was designed to meet certain standards, they must be
maintained in good order and condition. To achieve this objective, both the structure and the seat belt should
be inspected on a regular basis (every time the tractor is serviced).
In the event that the seat belt is damaged or frayed, it should be replaced and in the event that the ROPS
frame or any part of the mounting structure is damaged or cracked, the faulty component must be replaced
with a new unit. Such a unit must meet all of the test criteria of the original unit. Fitment of an inferior item or
items affects the certification of the entire ROPS structure and the effectiveness of the structure in the event
of an accident. Drilling or welding of the ROPS structure is forbidden.
Damage of the ROPS
Cabin type
Warning: Do not weld, drill or straighten the ROPS.
Warning: Never attach chains, ropes to the ROPS for pulling purposes; this will cause the
Tractor to tip backwards. Always pull from the Tractor drawbar. Be careful when driving through
door opening or under low overhead objects. Make sure there is sufficient overhead clearance for the
ROPS fatal injuries.
Warning: If the ROPS is removed or replaced, make certain that the proper hardware is used to
replace the ROPS and the recommended torque values are applied to the attaching bolts.
Warning: Always wear your seat belt if the tractor is equipped with ROPS.
If the tractor has rolled over or the ROPS has damaged
(such as striking an overhead object during transport), it
must be replaced to provide the original protection. After
an accident, check for damages to the 1.ROPS.2.Seat
3.seat belt & seat mountings. Before you operate
a Tractor, replace all damaged parts.
U18N003
ROPS (ROLL OVER PROTECTION STRUCTURES)
15