Smart Connect
Single loop touch screen panel
Doc: GLT-229-7-2
11
Issue: 1
Date: 11/03/2016
5.4 TURNING ON THE ALARM SOUNDERS FROM THE FACP (TO EVACUATE THE BUILDING)
If a user comes across a fire in the protected building, the alarm can also be raised by operating the START SOUNDERS
button on the front of the Fire Alarm Control Panel.
First enter the user access code, and then press the Start Sounder button to operate the Alarm sounders.
Pressing the STOP SOUNDERS button will Silence the Alarm Sounders.
Note: If ALL of the Alarm Sounders have been disabled, pressing the STOP or START SOUNDERS BUTTON will have no effect.
5.5 RESETTING THE PANEL
Check the cause of the alarm activation. If the cause of the alarm was an activated call point, reset it (if a resettable type),
or fit a new glass element (if a glass type). If the cause of the alarm was by detector activation the smoke (or steam or
other stimulus) will have to be cleared from the room before the panel can be reset. Reset the panel by pressing the reset
button after the sounders and panel buzzer have been silenced.
If the call point is still active, or the detector is still smoky, this will cause another alarm straight after the panel is reset,
and the alarm sounders will start again.
